Vocera Badge Guide de l'utilisateur télécharger pdf (Page 77)

Configuring New Badges ··· 77

Configuring Badges with Static IP Addresses

You cannot use the Badge Properties Editor to assign static IP addresses, because

each static address must be unique. Therefore, each badge that uses a static IP

address must be configured manually. Because this is a slow and potentially

error-prone process, use a DHCP server to assign IP addresses to badges

whenever possible.

Use static IP addresses only in the following situations:

• You are setting up a small evaluation system.

• Static IP addresses are mandatory at your site.

To configure badges with static IP addresses:

1. Set up the configuration computer.

See Setting Up the Configuration Computer on page 57.

2. Set up the isolated access point.

See Setting Up an Isolated Access Point on page 60.

3. Use the Badge Properties Editor to specify the badge properties required by

your site, as described in Creating a Property File to Download on

page 64.

a. On the General, Security, and Advanced tabs of the Badge Properties

Editor, follow the instructions in Setting General Properties on

page 65, Setting Security Properties on page 66, and Setting

Advanced Properties on page 72.

b. On the TCP/IP tab of the Badge Properties Editor, check Use Static

Settings, then enter values for the following fields as described in

Setting TCP/IP Properties on page 70:

• Subnet Mask

• Default Gateway

• Preferred DNS

• Alternate DNS

c. Click OK to save these values and close the Badge Properties Editor.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 257 258

Pas de commentaire

Vocera Badge Guide de l'utilisateur Page 77